amprobe
Australia [Change Country]
Home  |  Products  |  Clamp Meters  |  Multimeter Clamps  |  
Contact usRefer this page

Amprobe ACD-10 TRMS-PLUS 600A Clamp Multimeter


Amprobe ACD-10 TRMS-PLUS 600A Clamp Multimeter
Amprobe ACD-10 TRMS-PLUS 600A Clamp Multimeter
Amprobe ACD-10 TRMS-PLUS 600A Clamp Multimeter
Amprobe ACD-10 TRMS-PLUS 600A Clamp Multimeter

Amprobe ACD-10 TRMS-PLUS meter offer thinner jaws over standard clamp meters. Allowing access to tight measurement areas and still accommodating conductors up to 25 mm. Both meters also measure Capacitance and Frequency. Frequency is measured by either jaws or test leads. Very versatile clamp multimeters. True-rms version for noisy measurement environments for a more accurate reading.


  • AC & DC Voltage to 600V
  • AC Current to 600A
  • Thin Jaws, only 10mm (0.4”) thick
  • Resistance to 40MΩ
  • Continuity Buzzer
  • Capacitance to 3000 uF
  • Frequency measurement
  • In rush current
  • Hold & Maximum reading functions
  • Accommodates conductors up to 26mm (1.02”) in diameter
  • Auto ranging
  • Auto power off
  • Rubber over-molded case
  • Overload protected
  • TRMS Measurement
  • Included Accessories:Test leads, battery installed, soft carrying pouch, and users manual
Display:    3-3/4 digits 4000 counts LCD display
Update Rate    3 per second nominal
Polarity:    Automatic
Operating Temperature:    °C to 40 °C; < 80% RH for temperature up to 31 °C decreasing linearly to 50% RH at 40 °C
Altitude:    Operating below 2000m; Indoor use
Storage Temperature:    -20 °C to 60 °C, < 80% RH (with battery removed)
Temperature Coefficient:    nominal 0.15 x (specified accuracy)/°C @(0 °C ~ 18 °C or 28 °C ~ 40 °C)
Low Battery:    Below approx. 2.4V
Power Supply:    3V coin battery IEC-CR2032
Power Consumption:    2.8 mA typical except that 3.3 mA typical for ACA function
APO Timing:    Idle for 30 minutes
APO Consumption:    5 μA typical
Jaw Opening & Conductor Diameter:    max 26 mm
Special Features:    30ms Max Hold; Data Hold; Relative Zero mode
Model NameDescription
ACD-10 TRMS-PLUS
  • TRMS Measurement
  • AC & DC Voltage to 600V
  • AC Current to 600A
  • Thin Jaws, only 10mm (0.4”) thick
  • Resistance to 40MΩ
Included Accessories:   Test leads, battery (installed), soft carrying pouch, users manual

Test Leads Probes and Clips
DL248DAmprobe DL248D

Other
ELS2AELS2A AC Current Clamp Accessory
Search
Find Resources
Find Products
Related Products

 Write the first review
 
 Amprobe ACD-10 PLUS 600A Clamp Multimeter »

 Write the first review
 
 Amprobe ACD-14 PLUS Dual Display Clamp Multimeter with Temperature »

Follow us  Google+       Home  |  About Us  |   Privacy Statement  |  Site Map  |   Contact Us© 1995 - 2017 Amprobe